After I was interrupted in the work with eQmail a few months ago, finally eQmail-1.10 is out. It is not a release with a lot of new features, against the focus was laid at the internal code base. I did made an announcement of changes here - but the following are the facts what changed really. Let's start from the
 qmail-tcpsrv 
1) - was  tcpserver 
from ucspi-0.88 - for sure with IPv6. The thoughts behind this change were tcpserver 
was(/is) a quasi requirement it breaks eQmail's dependency on ucspi-tcp (it is still the choice of the user what to use) qmail-shcfg 
replaces the former  qmail-showctl 
. It gives a better and more complete overview of eQmail's configuration. The old tool was often ignored by patch authors. qmail-fixq 
and the extended  qmail-qstat 
have most of the functionality of the third party tools queue-repair, queue-fix and qmHandle. qbiff 
,  qmail-{popup,pop3d} 
,  pinq 
,  elq 
,  qail 
,  qsmhook 
and  qmail-upq 
. I don't expect that they will be missed.  ./configure - make - make install 
. A basic configuration will be created automatically if necessary. netqmail-1.06-tls-20160918.patch 
.Short: there was a massive code refactoring.
 qlibs 
 qlibs 
to buffereQmail-1.10 was tested to build and run at the following systems:
 openssl 
for TLS)Still, eQmal-1.10 isn't a release with a lot of new features. Indeed the focus is set to internal optimizations. This - the code-cleanup - is a ongoing process.